Rust ESP Board by esp-rs

About Rust ESP Board

Rust ESP Board is Open Hardware with ESP32-C3 compatible with Feather specification designed in KiCad.

Rust ESP Board Specification

This board is based on the ESP32-C3, and includes sensors, LEDs, buttons, a battery charger, and USB type-C connector.

SoC Features

•     IEEE 802.11 b/g/n-compliant
•     Bluetooth 5, Bluetooth mesh
•     32-bit RISC-V single-core processor, up to 160MHz
•     384 KB ROM
•     400 KB SRAM (16 KB for cache)
•     8 KB SRAM in RTC
•     22 × programmable GPIOs
•     3 × SPI
•     2 × UART
•     1 × I2C
•     1 × I2S
•     2 × 54-bit general-purpose timers
•     3 × watchdog timers
•     1 × 52-bit system timer
•     Remote Control Peripheral (RMT)
•     LED PWM controller (LEDC)
•     Full-speed USB Serial/JTAG controller
•     General DMA controller (GDMA)
•     1 × TWAI®
•     2 × 12-bit SAR ADCs, up to 6 channels
•     1 × temperature sensor

Rust ESP Board Pinout

Rust ESP Board Bill Of Materials (BOM)

Rust ESP Board interactiveHTML BOM

More information about Rust ESP Board can be found in the esp-rs github page below:

Rust ESP Board by esp-rs