0.96 Inch 128x64 SPI Display Module KiCad Custom Footprint
0.96 Inch 128x64 SPI Display Module KiCad Custom Footprint
0.96″ oled 128×64 resolution display (blue) SPI module for Arduino with ultra-low power consumption – full screen lit 0.08W , SSD1306 driver.
Interface:
- GND: Ground
- VCC: 3.3-5V
- SCK: Serial Clock
- SDA: Serial Data
- RES: Reset (When held to ground momentarily this pin resets the module)
- DC: Command pin (Can either be used for SPI or for IIC)
- CS: Chip Select (Normally held low, used only when more than one SPI device is connected to MCU)
- Super High Brightness (Adjustable)
- Super High Contrast (Adjustable)
- Embedded Driver/Controller
- Colors: Blue
- Drive Duty: 1/64 Duty
- Pixels: 128×64
- Panel Size: 26.70mm x 19.26mm x 1.85mm
- Active Area: 21.74mm x 11.2mm
- Pixel Size: 0.15mm x 0.15mm
- High resolution: 128 * 64
- Viewing angle:> 160 °
- Supports many control chips: Fully compatible with Arduino, 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc.
- Ultra-low power consumption: full screen lit 0.08W
- Voltage: 3V ~ 5V DC
- Working Temperature: -30 ℃ ~ 70 ℃
- Module Size: 27.0MM * 27.0MM * 4.1MM
- SPI - 2 times faster than I2C
- Driver IC: SSD1306
Download 0.96 Inch 128x64 SPI Display Module KiCad Custom Footprint
Download 0.96 Inch 128x64 SPI Display Module KiCad Custom Footprint created in KiCad 6, below:
0.96 Inch 128x64 SPI Display Module KiCad Custom Footprint
